Specification Sheet

Document Name
Document No.
Date
Page
CR2032
Specification
ZJQM-RD-SPC-H0374
2019-4-29
10/12
Button lithium batteries need special method to avoid short-circuiting before and after they are installed. As short
circuits tend to occur in the following cases, please take care when handing the batteries
+ 60℃，120 天储存条件相当于室温下 6 年（+ 21℃）。
纽扣锂电池需要特殊的方法，以避免安装前后的短路。 由于在下列情况下容易发生短路，请在搬运电池
时注意

Overlapping Batteries 重叠电池
A Button lithium battery is shaped as shown below. It has exposed positive and negative metallic surfaces with a
thin cylindrical seal, called the gasket, in between.
纽扣锂电池的形状如下所示。它暴露出正负金属表面，中间有一个薄的圆柱形密封，称为垫圈。
When batteries are overlapped or mixed together in a disorder way, their positive and negative terminals touch
each other, causing short circuits.
当电池以无序方式重叠或混合在一起时，它们的正极和负极端子相互接触，导致短路。

Batteries put in a Metallic Container or on a Metallic Plate 电池放在金属容器或金属板上
Similar to the overlapping battery problem, when batteries are put in a metallic container or on a metallic plate,
their positive and negative terminals may short circuit through the conductive surface depending on the
placement
类似于重叠电池问题，当电池放入金属容器或金属板上时，它们的正极和负极端子可能会因导电表面而
短路，这取决于放置位置。

When a Battery is Held with Tweezers 用镊子拿电池时
When held with a pair of metallic tweezers as shown below, the battery short-circuits through the tweezers
当用如下所示的一对金属镊子固定时，电池通过镊子短路