Installation guide

3 EX9001-48
1) MOUNTING THE UNIT TO THE WALL
1) The heater should be mounted “under the sink” as close to the point of use as possible. “Single
Point” will have the brass fittings on the top pointing “up”. “Flow Controlled” and “Thermostatic” will
have the fittings on the bottom pointing “down”.
2) The fittings must be pointed in
the vertical direction and be at
least 16 inches below the level of
the hot water faucet. Make sure
to leave a minimum of 8 inches
service clearance at the end
OPPOSITE the fittings.
3) Remove the cover and fasten
to the wall using the four
mounting holes at each corner of
the back plate. Make sure the
“UP” arrow on the circuit board is
facing “UP”. Replace the cover.
If you need any assistance from our Technical Service Department, make sure you can identify this water
heater by having the model no:____________________ and serial no:________________________.
Call 203-267-7890 or toll free: 800-543-6163.