Installation guide

2 EX9001-48
Connect only to a circuit protected by a Class A ground fault circuit interrupter.
Attention: Brancher uniquement à un circuit protégé par un disjoncteur de fuite de terre de Classe A.
(Canadian Installations Only)
Do not install in a bath enclosure or shower stall or connect to a salt-regenerated
water softener or a water supply of salt water. Attention: Ne pas installer dans une baignoire ou une
cabine de douche et ne pas brancher à un adoucisseur d’eau régénéré avec du sel ou à un
approvisionnement en eau salée. (Canadian Installations Only)
Use copper conductors only. Use bonding conductor in accordance with the Canadian Electrical Code
Part I. Utilisez dez conducteurs en cuive uniquement. Utilisez des conducteurs de mize à la masse
conformement au Code Canadien de L’Électricité, Partie I. (Canadian Installations Only)
SAVE THESE INSTRUCTIONS
GENERAL
The Eemax “Single Point” or “SP”, “ Flow Controlled” or “EX” and “Thermostatic” or “EX_T” heaters will
provide optimum performance and energy savings when located under the sink and as close as possible
to the point of hot water use. The heater should be BELOW the point of use. Failure to do so may void
the warranty. Contact your Eemax representative for further information.
“Single Point” heaters take in cold water ONLY and heat it to temperatures suitable for hand washing.
“Flow Controlled” heaters take in cold water ONLY and heat it to temperatures suitable for normal
domestic usage up to a maximum of 140 degrees F.
“Thermostatic” heaters take in cold or preheated water and heat it to temperatures suitable for normal
domestic usage up to a maximum of 140 degrees F. With the “S” option, they can be used as a
temperature booster for sanitation applications like dishwashers or commercial kitchens. This is the
only heater of the three with thermostatic control.