Installation Guide and Manual

20
TECHNICAL SUPPORT
TECHNICAL SUPPORT FORM
PERFORM STEPS BELOW BEFORE CALLING TECHNICAL SUPPORT
1 [phone]
WATER HEATER
MODEL # ____________________________________ SERIAL # ____________________________________
Inlet Water Pressure ____________________ Inlet Water Temperature ____________________
Incoming Voltage
L1 ____________
L2 ____________
L3 ____________
Testing Elements
Amp draw on each heating element,
place clamp on each red wire on inlet
side of contactor.
E1 ______ E2 ______ E3 ______
E4 ______ E5 ______ E6 ______
Testing Elements
Ohm out heating elements: place
#1 lead on 1 terminal on right side
of SSR (FIG 1); place #2 lead (FIG 2)
on the matching numbered red
wire on outlet side of contactor
GPM FLOW RATE _____________
LOAD PERCENTAGE _____________
FIG 1
FIG 2
Wire #1 TAG