Manualshelf

User manual

ManualsBrandsEE ManualsComputer equipmentBrightbox
191192193194195196197198199200
EE Bright Box User Manual
196
The Point-to-Point Protocol has sent or received a
Configure-Request message.
The Point-to-Point Protocol has sent or received a
Configure-ACK (Acknowledge) message.
The Point-to-Point Protocol has sent or received a
Configure-NAK (Negative Acknowledge) message.
The Point-to-Point Protocol has sent or received a
Configure-Reject message.
The Point-to-Point Protocol has initiated a request
to terminate the PPP connection.
The Point-to-Point Protocol has responded to the
TERMREQ with an acknowledgement to close the
PPP connection.
A connection to the Internet has been established
using Point-to-Point Protocol.
A previous connection to the Internet has been lost
over Point-to-Point Protocol.
Link Control Protocol is up.
Link Control Protocol is down and the Internet
connection has been lost. May indicate a problem
with the broadband line, or an incorrect broadband
username and password.
Internet Protocol Control Protocol is up
Internet Protocol Control Protocol is down. May
indicate a problem with the broadband line, or an
incorrect broadband username and password.
Broadband authentication has been successful.
Broadband authentication has failed, check to see
whether the broadband username and password are
correct.
Challenge Handshake Authentication Protocol is not
supported on this broadband connection. Check
that you are using the correct authentication
protocol for your broadband line.
Password Authentication Protocol is not supported
on this broadband connection. Check that you are
using the correct authentication protocol for your
broadband line.
The router has detected a Denial of Service attack
from the listed IP and MAC Address.
A Denial of Service attack may be triggered by the
following events - Zero Length IP, Ping of Death, IP
Spoofing, Smurf Attack, Snork Attack, UDP Port