User`s guide

MaxLoader User’s Guide
25
 Make sure the USB driver is installed after MaxLoader software is set up in
a PC. The USB drivers are located in : C:\program files\EE Tools\Drivers\x86
(for 32-Bit CPU size) or C:\program files\EE Tools\Drivers\x64 (for 64-Bit
CPU size)
 Make sure that the programmer hardware unit is connected to your PC
printer port or USB port directly. A programmer for parallel port interface will
not work with multiple port connectors or convertor(USB-to-Parallel).
 Be sure your printer cable is firmly connected to your computer and the
programmer. Plug in the AC power cord to your programmer and turn on the
switch in the back of the unit before clicking on the MaxLoader icon.
NOTE: The MaxLoader detects the printer port address when you install the
new software. When you see “Cannot find the programming module,” go to
CONFIG/PORT and select all three parallel port addresses. If the same error
message continues, contact technical support.
3. FAMILIES OF PROGRAMMABLE DEVICES
The devices that are supported on the EE Tools, Inc programmers are:
 NVM: Non Volatile Memory
 ROM: Read Only Memory
 OTP: One Time Programmable ROM
 EPROM: Erasable Programmable ROM
 EEPROM: Electrically Erasable & Programmable ROM
NVM Hierarchy