User`s guide

MaxLoader User’s Guide
114
otherwise you have to install the USB drivers again for different port. Do
not power Off and ON in 30 seconds and you must wait over 30 seconds
once you un-plug an USB cable from PC (USB Hub) and plug-in the same
cable. Programmer for USB interface need to be installed in a PC with
USB 2.0 port. (Programming errors will be occurred in USB 1.1 port)
 Any of convertor or adapter for USB / Parallel communication will not
work for all USB programmers.
 Be sure the device selected matches the device being used.
 For multi-site programmer usage, make sure all devices are identical.
 For a device that uses an adapter, be sure that the adapter is correctly
oriented, seated properly, and the ZIF socket lever is down.
 Be sure power cord is securely attached to programmer and power pack to
wall socket.
 Be sure that power switch is ON.
 Be sure that the parallel cable (IEEE standard, 25 pins and wires) is
correctly and securely attached to the programmer and PC. The connection must
be direct; there cannot be any software keys or locks between the parallel port
and the programmer. Most switch boxes may also cause difficulties.
 You may need to change your printer port [even though it is working fine
with your printer] because TopMax / ChipMax communicate with your
computer via the printer port in a bi-directional mode.
 For new device support, TopMax is no longer supported since January
2006. TopMax will be upgraded to TopMaxII. Please contact
[e-mail] for further question.
5. Contacting Customer Support
EE Tools provides telephone technical assistance during normal business hours
(9:00 AM to 5:00 PM, Pacific Time).