Cut Sheet

FIRE ALARM EQUIPMENT
90 Fieldstone Court
||
||
| Cheshire, CT 06410
Ph: 203.699.3300
||
||
| Fx: 203.699.3108
www.edwards-signals.com
12-27
© Copyright 2004 Edwards
dBA OUTPUT - HIGH dB SETTING
UL464 Average Peak
Temporal Steady Temporal/Steady Temporal/Steady
16 Vdc 81.4 85.5 91.4 94.2
24 Vdc 84.4 88.6 94.5 97.6
33 Vdc 86.3 90.4 96.9 99.5
dBA NOTES
1. All values shown are dBA measured at 10 feet (3.01m).
2. UL 464 values measured in reverberation room.
3. Average and Peak values are measured in anechoic chamber.
dBA OUTPUT - LOW dB SETTING
UL464 Average Peak
Temporal Steady Temporal/Steady Temporal/Steady
16 Vdc 76.0 80.1 86.3 89.2
24 Vdc 79.4 83.5 89.8 92.5
33 Vdc 82.1 86.5 92.5 95.3
EG1-P dB OUTPUT
UL464 Average Peak
20 Vdc 76.7 89.5 91
24 Vdc 77.1 90 91.1
31 Vdc 77.2 90.4 91.6
ORDERING INFORMATION
Catalog Number
White Red Description
EG1-HDVM EG1R-HDVM Genesis Horn/Strobe (selectable 15, 30, 75, or 110 cd output, selectable high/low dB output)
EG1-VM EG1R-VM Genesis Strobe (selectable 15, 30, 75, or 110 cd output)
EG1-HD EG1R-HD Genesis Temporal Horn (selectable high/low dB output)
EG1-P EG1R-P Genesis Steady Horn (not compatible with Genesis Signal Master)
EG1F-HDVM EG1RF-HDVM Genesis Horn/Strobe (selectable 15, 30, 75, or 110 cd output, selectable high/low dB output)
- with "FIRE" marking
EG1F-VM EG1RF-VM Genesis Strobe (selectable 15, 30, 75, or 110 cd output) - with "FIRE" marking
EG1F-HD EG1RF-HD Genesis Temporal Horn (selectable high/low dB output) - with "FIRE" marking
EG1F-P EG1RF-P Genesis Steady Horn with "FIRE" marking (not compatible with Genesis Signal Master)
Mounting Accessories
EG1T EG1RT Genesis Trim Plate (for two-gang or 4" square boxes)
EG1T-FIRE EG1RT-FIRE Genesis Trim Plate (for two-gang or 4" square boxes) with "FIRE" markings
27193-16 27193-11 One-gang surface mount box
Synchronization Modules
EG1M Genesis Signal Master - Snap-on Mount
EG1M-RM Genesis Signal Master - Remote Mount (1-gang)
Genesis horns and strobes mount to any standard
one-gang surface or flush electrical box. Matching
optional trim plates are used to cover oversized
openings and can accommodate
one-gang, two-gang, four-inch
square, or octagonal boxes, and
European 100 mm square.
Temporal models are factory set to
sound in a three-pulse temporal
pattern. Units may be configured for
use with coded systems by cutting a
jumper on the circuit board. This
results in a steady output that can
be turned on and off (coded) as the system
applies and removes power to the signal circuit. A
Genesis Horn-
strobe with optional
trim plate
Genesis Signal Master is required when horn-strobe
models are configured for coded systems. Non-
temporal, horn-only models sound a steady tone.
Models are shipped from the factory ready for use as
UL 1971 compliant signals for public mode operation.
These signals may be configured for temporal flash
be cutting a jumper on the circuit board.
Strobes and horn-strobes may be set for 15, 30, 75 or
110 candela output. The device does not have to be
removed to change the output setting. The setting
remains visible through a small window on the side of
the device after the cover is closed.
Models are factory set for high dB output. Low dB
output may be selected by cutting a jumper on the
circuit board which reduces the output by about 5 dB.
D-04