Instruction Manual

P/N 3100125 ISSUE 3PAGE 13

WARNING

To prevent electrical shock, disconnect network

and local power to the unit. Wait 5 minutes for

stored energy in strobe modules to dissipate before

working on unit.

WARNING

Ensure the magnifier ring on the lens cover and the

magnifier ring on the lens module are aligned

(Figure 1).

MaintenanceMaintenance

Maintenance

Light Source Replacement

1. Loosen captive screws and remove cover of affected lens module.

2. Remove the light source assembly from the lens module.

3. Install new light source assembly ensuring that the four prongs on the PC board are aligned with the plug

located in the back of the lens module.

4. Replace lens cover and secure using two captive screws.

Cleaning

The lens surfaces should be periodically dusted and cleaned with a dry soft clean cloth to maintain optimum light

visibility. If necessary, the outside of the lens may be cleaned with water and a mild detergent on a well rung out soft

clean cloth.