Product Manual B

4
Starting Box Wiring
Provide the electrical schematic wiring diagram (located within
the Ironworker control box) to your Electrician prior to initiating the
electrical hookup of the machine.
Power up the Ironworker
With all stations clear of tools, tooling or debris, power up the Ironworker
by depressing the green button on the starter box. With the power on,
your machine will return to a neutral position.
Cycle the machinery by depressing the foot pedal. If pressure is released
at the foot pedal prior to completing a full stroke, the operating center of
the machinery will return to a neutral position.
If the machinery fails to cycle the motor may be rotating incorrectly. To
ensure the machinery cycles properly simply reverse two of the phase
wires on the machine starter box.
If the machine fails to cycle, power down the Ironworker by depressing
the red button on the starter box, Lockout / Tagout the upstream power
and consult the trouble shooting section of the Operator Manual.