User's Manual

NOTE: You may wish to purchase further rechargeable batteries and battery chargers
for longer play sessions. See the order form for more details.
BATTERY INSTALLATION IN TRANSMITTER
1. Unscrew the battery cover at the bottom of the transmitter and place a 9-volt
battery inside following the engraved signs (see diagram).
2. Replace the battery cover.
BATTERY INSTALLATION IN VEHICLE
1. Unscrew the battery cover at the bottom of the vehicle and place the battery pack
inside the battery compartment.
2. Plug the battery connector into the motor harness connector.
3. Please note: if the battery connector will not plug into the motor harness
connector, turn it over and try again! Do not force the battery connector into the
motor harness connector.
4. Replace the battery cover by tightening the screw.
CARE, MAINTENANCE AND YOUR SAFETY
It is recommended that this toy and all accessories be periodically examined for potential
hazards and that any potentially hazardous parts be repaired or replaced.
- Always operate away from areas which can cause radio interference, (eg. power lines,
tall buildings.)
- DO NOT operate near concrete walls which may disturb transmission.
- DO NOT drive car through water or in sand.
- DO NOT bend the antenna.
- Make sure ON/ OFF switch on your vehicle is in the “OFF” position when it is not in
use.
- DO NOT leave the vehicle or transmitter near sources of heat or in direct sunlight for
long periods of time.
- Remove the batteries from the vehicle and transmitter when they are not in use.
- Brush areas where dirt and dust get trapped.
- Wipe body off with a soft rag or damp cloth.
- DO NOT clean vehicle with chemicals or water.
Parents must pay serious attention to handling the rechargeable battery properly: