Safety data sheet

EDSYN GMBH EUROPA
Zentrum für Löt- und Entlötsysteme
EDSYN GMBH EUROPA, Postfach 1169, D-97888 Kreuzwertheim
25.01.2018
EDSYN GMBH EUROPA • D-97892 Kreuzwertheim • Finkenweg 2 •  (09342) 6413 

 (09342) 6417
8.) EXPOSURE CONTROLS/PERSONAL
PROTECTION
8.1.) Control parameters
8.2.) Exposure controls
Appropriate engineering controls:
Protection and hygiene measures:
Eye/face protection:
Hand protection:
Skin protection:
Respiratory protection:
Environmental exposure controls:
Do not breathe gas/fumes/vapour/spray.
Remove contaminated, saturated clothing immediately. Protect skin by
using skin protective cream. After work, wash hands and face. When using
do not eat or drink.
For the protection against direct skin contact, body protective clothing is
essential (in addition to the usual working clothes).
Additional protection measures for the hands
Hand protection: DIN EN 374
-CR (polychloroprenes, Chloroprene rubber).
Thickness of glove material: 0,65 mm
penetration time (maximum wearing period): > 120 min.
-NBR (Nitrile rubber).
Thickness of glove material: 0,4 mm
penetration time (maximum wearing period): > 480 Min.
Breakthrough times and swelling properties of the material must be taken
into consideration.
Take recovery periods for skin regeneration.
In the case of wanting to use the gloves again, clean them before taking
off and air them well.
Use gloves only once.
When handling with chemical substances, protective gloves must be worn
with the CE-label including the four control digits.
Before using check leak tightness / impermeability.
For the protection against direct skin contact, body protective clothing is
essential (in addition to the usual working clothes).
(In case of inadequate ventilation) wear respiratory protection. Use
appropriate respiratory protection. Use only respiratory protection
equipment with CE-symbol including four digit test number. The filter class
must be suitable for the maximum contaminant concentration
(gas/vapour/aerosol/particulates) that may arise when handling the
product. If the concentration is exceeded, closed-circuit breathing
apparatus must be used!
Filtering device (full mask or mouthpiece) with filter: A
No special measures are necessary.
9.) PHYSICAL AND CHEMICAL
PROPERTIES
9.1.) Information on basic physical and
chemical properties
Physical state:
Colour:
Odour:
solid
light yellow – bright green
characteristic