Certifications 2

EDSYN GMBH EUROPA
Zentrum für Löt- und Entlötsysteme
EDSYN GMBH EUROPA, Postfach 1169, D-97888 Kreuzwertheim
24.03.2021
EDSYN GMBH EUROPA  D-97892 Kreuzwertheim  Finkenweg 2   (09342) 6413

(09342) 6417
Eye/face protection:
Skin protection:
Respiratory protection:
8.2.3) Environmental exposure controls
Eye glasses with side protection DIN EN 166
Tested protective gloves must be worn EN ISO 374. Suitable material:
Breakthrough time (maximum wearing time) min. In the case of wanting to
use the gloves again, clean them before taking off and air them well.
Breakthrough times and swelling properties of the material must be taken
into consideration.
If technical exhaust or ventilation measures are not possible or insufficient,
respiratory protection must be worn.
No data available.
9.) PHYSICAL AND CHEMICAL
PROPERTIES
9.1.) Information on basic physical and
chemical properties
Appearance
Physical state:
Colour:
Odour:
Safety relevant basis data
parameter
ph:
Melting point :
Freezing point:
Initial boiling point and boiling range:
Decomposition temperature:
Flash point (°C):
Evaporation rate:
Auto-ignition temperature:
Upper/lower flammability or explosive
limits:
Vapour pressure:
Vapour density:
Densitiy:
Bulk density:
Water solubility:
Partition coefficient: n-octanol/water:
Dynamic viscosity:
Kinematic viscosity:
9.2.) Other information
liquid
yellow
earthy
at °C Method Remark
6 20 °C
not determined
not determined
150 – 160 °C
not determined
240 °C
not determined
not determined
not determined
not determined
not determined
0.9 g/cm³ 20 °C
not determined
practically insoluble
not determined
not determined
not determined 40°C
No data available
10.) STABILITY AND REACTIVITY
10.1.) Reactivity
10.2.) Chemical stability
10.3.) Possibility of hazardous reactions
10.4.) Conditions to avoid
Combustible
The mixture is chemically stable under recommended conditions of
storage, use and temperature.
No data available
No data available