Assembly Instructions

Instructions : MEN2472W3
Instructions : MEN2472W3
Instructions : MEN2472W3
-
-
-
Bulk Storage Rack
Bulk Storage Rack
Bulk Storage Rack
Should you have any comments, damage, missing parts, or problems with assembly
of this unit please feel free to contact our manufacturing facility at,
[phone] for customer service.
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description - Location Purchased - Date Purchased
General Instructions
General Instructions
General Instructions
(2) - 24” x 72” Welded End Frames
(6) - 72” Beams
(3) - Wire Deck Shelving
(3) - 23 1/4” Tie Bars
(12) - Plastic Push Clips
(6) - Nuts and bolts
Parts
Safety Instructions
Safety Instructions
Safety Instructions
Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly. The rack units
can stand individually, or for greater stability, be joined together using the common post. Individual beams can be ad-
justed without disturbing the beams in adjoining units. These instructions should be followed exactly. All parts supplied
must be used as shown. Any alteration or deviation from this instruction sheet can result in unit failure. After the unit is
assembled, it must be placed on a level surface for safety, and optimal product performance.
This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product perform-
ance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER !
DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.
Use care and the proper attire when working with metal parts.
Assembly Instructions
Assembly Instructions
Assembly Instructions
Attach the beams to the welded end frames as seen in
figure 1. Use both welded end frames to establish the
left and the right sides of the units. After a beam has
been placed to the end units, tap the beam down at
both ends with a rubber mallet to help drive the beam
end clip tabs into the end frame post slots to secure the
beam to the end frame (see figure 1). Note: If the
beam end clip tabs become bent due to mishan-
dling. It may be necessary to adjust the tabs back
to their proper form. Place a plastic push clip into the
hole of the beam end clip, then tap the plastic clip with
a mallet to drive it into the hole of the end frame post to
secure the beam to the end frame (see figure 1).
The unit should have three (3) levels evenly spaced for
maximum stability. Although the beams are adjustable
in height, it’s recommended to evenly space them so
that the stability of the unit is not compromised. Tie bar
supports are provided with this unit. Tie bars are used
to assist with a heavy load. Insert a tie bar to a level by
aligning the holes located on the ends of the tie bar, to
the holes located toward the center and on the inside
bottom edge of the beams (see figure 2). Use the nuts
and bolts provided to properly fasten.
After all beams are in place, place the wire deck shelv-
ing on each level (see figure 3).
Tools Required
Rubber Mallet
Adjustable Wrench
Blade Screw Driver
Figure 1
Beam End
Clip Tabs
Beam
End Frame Post
End Frame Post Slots
Plastic
Push Clip
Made in USA
Edsal Manufacturing Co., Inc.
Chicago, IL
Figure 3
Wire Decking
Figure 2
Atlantic Metals Inc.