Installation guide

++.
 #
!
If you purchased any printer options, such as extra memory (SIMMs), then install them
now. If installation instructions are included with the option, follow them. If not, installa-
tion instructions are included in chapter 5, “Printer Options,” of the
QMS magicolor 2
DeskLaser User’s Guide
.
»Note:
Remember to turn off the printer before you install an option.
(
1 Using a twisted-pair (RJ45) Ethernet cable, con-
nect the Ethernet port on the printer to a 10BaseT
concentrator.
If you’re replacing a printer already connected to an
Ethernet network, you may already have a twisted
pair (RJ45) Ethernet cable. If not, contact your local
vendor or computer store.
Also, see appendix B, “Technical Specifications,” of
the
User’s Guide for detailed information on
PC-to-printer cabling.
2 Plug the printer into a grounded, surge-
protected, electrical outlet.
»Note:
In compliance with UL guidelines, “The appliance inlet is considered to
be the main disconnect device.”
0

EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]