Specifications

Using Media
Other than
Paper
QMS magicolor 2 Op
eration2-6
5 Adjust the media guides to the length and width of the enve-
lopes.
Squeeze the retainers at the ends of the left width guide and/or
the length guide, move the guide to the appropriate location
(media sizes are listed on the cassette), and release the retainers.
» Note:
Make sure the guides are snug enough to keep the
envelopes straight, but not so tight that they buckle the
envelopes.
6 Place the envelope stack into the cassette with the printing-
side up.
» Note:
Check your application documentation to determine if the flap
should be placed on the left or on the right. You can also print a single
envelope to check the orientation before printing multiple copies.
7 Insert the cassette into the printer.
The media cassette must be located in the upper position, not in
the optional lower input feeder.
8 Open the flap of each envelope immediately (before it cools)
after the envelope is delivered to the output tray.
» Note:
Because the envelopes pass through heated rollers, the
gummed area on the flaps may seal. Using envelopes with
emulsion-based glue avoids this problem.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]