User`s guide

magicolor 8650 9-29
Settings for control panel
9
Expert Adjustment
2
Note
If "Print" is selected for [PrinterAdjustment], test print is performed through which you can check the
set value.
[Finisher Adjust] is displayed when the finisher is installed.
Settings for [Center Staples Pos] and [Half-Fold Pos] in [Finisher Adjust] vary depending on the finisher
installed. When FS-609 is installed, the values for position adjustment can only be specified. When
FS-519 is installed, the values for position adjustment can be specified for each paper size or paper
type.
Menu Description Default
Setting
PrinterAdjustment Leading Edge Adj. Adjust the starting print position between -3.0 and
3.0mm at the leading edge of the paper (with respect
to the paper feed direction). Adjustments can be spec-
ified for each paper type.
0.0mm
Centering Adjust the starting print position between -3.0 and
3.0mm at the left edge of the paper (with respect to the
paper feed direction). Adjustments can be specified
for each paper tray.
0.0mm
Leading (Duplex) Adjust the starting print position between -3.0 and
3.0mm at the leading edge of the paper for the second
side during automatic double-sided copying. Adjust-
ments can be specified for each paper tray.
0.0mm
Centering (Duplex) Adjust the starting print position between -3.0 and
3.0 mm at the left edge of the paper for the second side
during automatic double-sided copying. Adjustments
can be specified for each paper tray.
0.0mm
Vertical Adj. Specify a zoom in the paper feed direction within the
range from -7 and +7.
0
EraseLeadingEdge Specify the non-printing area of the leading edge of
the paper.
4mm
Finisher Adjust Center Staple Pos Adjust the stapling position (between -10 and 10mm)
when printing with the "Center Staple & Fold" setting.
00mm
Half-Fold Pos. Adjust the folding position (between -10 and 10mm)
when printing with the "Center Staple & Fold" setting.
00mm
DensityAdjustment Thick/Yellow Adjust the image density for printing on thick paper or
transparencies. The density can be adjusted separate-
ly for each color (yellow, magenta, cyan and black for
a color image and the black image density). The higher
the setting, the darker the density.
Adjust the setting for yellow, magenta, cyan and black
between -5 and +5.
Adjust the setting for "Black Image Density" between -
2 and +2.
0
Thick/Magenta 0
Thick/Cyan 0
Thick/Black 0
BlackImageDensity 0
Stabilization Initialize+Stabi. Perform an image stabilization if the image is incorrect,
even after the gradation levels have been adjusted.
• Initialize+Stabi.: Perform a normal image stabiliza-
tion.
• StabilizationOnly: Select when a good result was
not achieved after "Initialize+Stabi". was selected.
Initial-
ize+Stabi.
StabilizationOnly
ColorRegistration Yellow Adjust the color registration if color shifts can be seen
in the print result.
0
Magenta 0
Cyan 0
Test Pattern Gradation Pattern Print the test pattern of each color gradation. –
Halftone Pattern Print the test pattern of each halftone. –
EDNord - Istedgade 37A - 900 Aalborg - telefon [phone]