User`s guide

Loading Media40
 All input trays—On the control panel, press the Menu key and
select Operator Control/Multipurpose Sz. Scroll to the required trans-
parency size and select it.
 Do not fan transparencies. Fanning transparencies will build up static
electricity.
3 Load the media tray.
 Upper and Optional Trays
Put media face side down in the
upper or optional trays.
 Multipurpose Tray—Open the multipurpose tray, adjust the media
guides to the width of the transparencies, and then place the transpar-
encies into the tray with the printing side up.
Attention
Improperly adjusted guides may cause poor print quality, media
jams, or printer damage.
4 Print the transparencies.
Immediately remove the printed transparencies from the output tray.
OHP
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]