User`s guide

Time-of-Day Clock148
1 Turn off the printer, and
then disconnect the
power cord and all
interface cables from the
printer.
2 Loosen the screws and
pull the controller board
from the printer.
WARNI NG!
Because the time-of-day clock includes an internal battery, there is a
danger of explosion if the clock is incorrectly installed or replaced.
Replace it only with a supported KONICA MINOLTA time-of-day clock.
Dispose of any used time-of-day clock in accordance with local laws
and regulations.
3 Attach the time-of-
day clock to the
controller board.
Attention
Make sure that the pins on the time-of-day clock are properly aligned
with those in the receiving socket on the controller board. Damage
to the time-of-day clock and/or controller board could result if the
pins are misaligned.
a Locate the time-of-day clock socket on the controller board and the pin
1 notch or printed label.
b Locate the pin 1 indicator mark on the top of the time-of-day clock.
This mark may be a notch or a slight depression on one end of the
clock.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIII
IIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIII II
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIII II
IIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIII
IIIIIIIII
Pin 1 indicator
Pin 1 notch/label
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]