User`s guide

Replacing Consumables
93
English
WARNI NG!
Dispose of the used waste toner bottle properly according to your local
regulations (do not dispose of it by burning).
Installing the New Waste Toner Bottle
1 Remove the new waste toner bottle from its carton.
2 Insert the bottom of the waste toner
bottle  into its installation position in
the printer.
3 Push the top of the waste toner bottle
 into position until it is firmly seated.
4 Close the printer’s front door.
If the waste toner bottle is not
correctly installed or the transfer belt
release lever is at its top position
(11 o’clock), the front door cannot be
closed.
 The printer must complete a 305-second calibration cycle after any
consumable has been replaced. If you open the door before the
display reads MAGICOLOR 2350/IDLE, the printer stops and repeats
the calibration cycle.
Replacing the OPC Drum Cartridge
When the OPC drum is worn out, the message REPLACE OPC DRUM appears.
Printing can continue even after this message appears; however, since print
quality is reduced, the OPC drum cartridge should replaced immediately.
 The OPC drum life is directly related to the number of rotations of the
drum. Longest drum life is achieved with continuous printing.
Intermittent printing with small job sizes requires cleaning rotations
before and after each job, and impacts OPC life.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]