User`s guide

Clearing Media Jams
117
English
Handling Media Jams by Location
Tray 1 (Multipurpose Tray)
1 Remove the media from the multipurpose tray.
2 Carefully remove the jammed media and discard it.
 Do not reinsert media that has jammed.
3 Fan the removed media to prevent static
buildup and even up the front edges.
 Don’t fan transparencies because
fanning increases static in them.
4 Reinsert the media printing face up.
Make sure the media is lying flat and
doesn’t exceed the media limit mark.
Check to see if the media width guides are correct.
5 Open the right-side door, then close it.
After the jam is cleared, opening and closing the door removes the media
jam message.
Tray 2 (Optional Lower Feeder Unit Media Tray)
1 Slide Tray 2 open and remove the media from it.
Location of Jam Page Reference
Tray 1 Page 117
Tray 2 Page 117
Inside the printer Page 119
Near the duplex option Page 122
In the output tray Page 122
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]