User`s manual

Optimuss OS User’s Manual
III. Start wizard
When you turn on Optimuss OS for the first time after purchase, an installation wizard will begin step
by step.
NOTE : OK key is used for confirmation and turns to the next step. Pressing exit key to return to the
previous page.
1. Video output selection
You will be shown different video output modes for roughly 10 seconds, after you have connected and
switched on your Optimuss OS. Once you see a clear picture on your TV screen press the OK button to
select it.
If you prefer a different output than the selected one you can use the Navigations buttons up/down and
the OK button to select it.
You can choose from the following video output options:
1. HDMI : using a HDMI cable.
2. YPbPr (YUV) : using a component cable.
Select your desired option with the Navigation
buttons up and down. Press the OK button to
activate.
You are taken to the next step.
You can now select the video mode.
The possible options strongly depend on the video
output mode you have selected in the step before.
Select your desired option with the Navigation
buttons up and down. Press the OK button to
activate.
You are taken to the next step.
2. Language selection
Select your desired language with the Navigation
buttons up and down. Press the OK button to
activate
- 18 -