User guide

ProductionVIEW Precision Camera Controller
ProductionVIEW Precision Camera Controller Manual 341-770 Rev. C Page 8 of 16
The 3-Axis Joystick:
Within the menus, the 3-axis joystick is programmable for pan, tilt and zoom direction control. The zoom-
in/zoom-out, tilt-up/tilt-down and pan-left/pan-right commands can be inverted on all 3-axis to customize
control of the PTZ cameras attached to Precision Camera Controller.
LCD Screen:
The LCD screen displays the menu structure, as well as information in real time as buttons are pressed,
or buttons pushed on the controller.
Note: The LCD is covered with a thin protective film, please remove this film carefully.
ProductionVIEW PRECISION CAMERA CONTROLLER Menu Structure
The ProductionVIEW Precision Camera Controller
has a back lit, 8-line LCD that displays the system
menus. The menus are traversed with the up/down
arrows, select and cancel buttons. The menu
structure is as follows:
1
st
Screen ProductionVIEW PC
V01.00.0X (software version 0X)
Rescan Cameras
Cam Search Menu
Default Camera
Default Preset
Rescan Cameras
>Select
>Start - Rescans control ports 1 through 7 to find the cameras connected
Cam Search Menu
>Select
>All Ports: (select search method – Auto, Sony, Canon, Panasonic)
>Port 01: (select search method – Auto, Sony, Canon, Panasonic)
>Port 02: (select search method – Auto, Sony, Canon, Panasonic)
>Port 03: (select search method – Auto, Sony, Canon, Panasonic)
>Port 04: (select search method – Auto, Sony, Canon, Panasonic)
>Port 05: (select search method – Auto, Sony, Canon, Panasonic)
>Port 06: (select search method – Auto, Sony, Canon, Panasonic)
>Port 07: (select search method – Auto, Sony, Canon, Panasonic)
NOTE: When using Panasonic cameras, it is necessary to select Panasonic to speed up the recognition of the
cameras when ProductionVIEW HD is turned on.
Default Camera (Automatic and Start-up Modes)
>Select
> 01 – 07
Selects camera 1 through 7 as the default camera (default is 01)
Default Preset (Automatic and Start-up Modes)
>Select
> 01 – 14
Assigns camera preset 1 through 14 as Default Preset on the default camera (default is 01)
CCU Mode
>Select
>All Ports: (Select method – Direct Cam Ctrl or CCU)
>Port 01: (Select method – Direct Cam Ctrl or CCU)
>Port 02: (Select method – Direct Cam Ctrl or CCU)
>Port 03: (Select method – Direct Cam Ctrl or CCU)
>Port 04: (Select method – Direct Cam Ctrl or CCU)
>Port 05: (Select method – Direct Cam Ctrl or CCU)
>Port 06: (Select method – Direct Cam Ctrl or CCU)
>Port 07: (Select method – Direct Cam Ctrl or CCU)
NOTE: When Vaddio Quick-Connect CCUs are used with ProductionVIEW Precision Camera Controller, CCU
mode disables Iris functions, AWB and BLC on the ProductionVIEW HD console, allowing the user to control
these functions from the Quick-Connect CCU)
Menu
Section