User guide

ProductionVIEW Precision Camera Controller
ProductionVIEW Precision Camera Controller Manual 341-770 Rev. C Page 6 of 16
LINK OUT
LINK IN
Secondary Primary
RS-232
LINK OUTLINK IN
MASTER Camera Set #2 - Control A
Camera Set #1 - Control B
MASTER Camera Set #1 - Control A
Camera Set #2 - Control B
Camera Set #1 Camera Set #2
Figure 5: Precision Camera
Controller connected with 7 PTZ
cameras directly.
Figure 6: Two Precision Camera Controllers set up in Link Mode. The Precision Camera Controller with the cameras connected is
the Primary, and the Precision Camera Controller without cameras is the Secondary unit.
Figure 7: Two Precision Camera Controllers set up in Link Mode. Each Precision Camera Controller has 7 cameras connected, and all
cameras can be controlled from either Precision Camera Controller, however not concurrently. There can be two operators, but only
one operator can access all fourteen cameras at any point in time. As an example, both the Master and the Secondary can operate
their own Control A bus cameras concurrently, but in order for the Master to control the B bus of the Secondary Precision Camera
Controller, then operator at the Secondary position must remain idle. An external switcher may not be connected to Precision Camera
Controller in Dual Link mode. Both Precision Camera Controllers must be set to Control A under the Camera Select Bus menu.