USB Audio Interface/ MIDI Keybroad Controller PC-80 Owner's Manual
Table Of Contents
- USING THE UNIT SAFELY
- Important Notes
- Contents
- Contents of the package
- Names of things and what they do
- Setup
- Operation
- Appendix
- Using the PC-80 as a MIDI controller keyboard
- Basic connection example and signal flow
- The PC-80’s basic operating modes
- Transmitting various MIDI messages from the PC-80
- Setting the MIDI transmit channel
- Selecting sounds—Transmitting Program Change and Bank Select Massages
- Starting/stopping playback data—Transmitting a Start/Stop/Continue message
- Transmitting messages to an external MIDI sound module
- Setting the split points
- Using the VALUE encoder to transmit values for a specified parameter
- Using the PC-80 as a MIDI interface
- Using the PC-80 as an audio interface
- System settings for the PC-80
- PC-80 driver settings
- Troubleshooting
- Driver-related problems (Windows)
- Can’t record or play back audio or MIDI/No sound
- Noise or pops are heard when recording/playing on your computer
- Noise or distortion occurs when the PC-80 is not connected to your computer
- The sound is too weak
- Problems with the PC-80 Software Synthesizer
- Won’t start up
- The menu does not appear correctly (can’t select it)
- No sound
- Sound is too loud/too soft
- Clicks, pops, or noise occurs in the sound
- Sounds you play from the keyboard are delayed
- Can’t control sounds or parameters from the PC-80
- Can’t play back song data/Playback is incorrect
- Can’t use the PC-80 software synthesizer from other software
- Uninstalling the PC-80 software synthesizer
- MIDI implementation
- Main specifications
- Index
- Using the PC-80 as a MIDI controller keyboard
75
Using the PC-80 as a MIDI controller keyboard
■
Transmitting a GM2 System On message
Here’s how to transmit a
GM2 System On message
.
fig.gm2-1_80
fig.util*
1
Simultaneously hold down the
MIDI CH
button and
PGM CHANGE
button for a few moments.
The display will indicate “UTL
”
and you will be in Utility mode.
fig.gm2
2
Press the keyboard key marked
[GM2 SYS ON]
.
The indication “GM2
”
starts blinking in the display.
fig.enter
3
Press the
ENTER
button.
* If you press a different button without pressing the
ENTER button
, the setting will be
cancelled.
The
GM2 System On message
has been sent.
213
PC-80_e.book 75 ページ ２００５年１１月１０日 木曜日 午前１１時３４分