Installation guide

15
7. This is the setting window when you click on setting on the previous device
type settings. The port name and the IP address would be pre-entered
for you from the previous settings. At the protocol line, choose LPR and
then you will be able to type in LPR settings. Type lpt1 on the queue
name and press OK.
8. After you press OK, you will return back to the device type window. Click
Next to continue with the setup.
9. This is the end of TCP/IP Port settings. The wizard will prompt you to
install the driver for your printer. If you already have the driver installed in
the computer, you would just choose the driver from the list on the right.
If not, click on have disk to install the driver for your printer. After you
have done that click on next to continue.
10. If you previously have the drivers installed then you should keep existing
driver.