User Manual


43


Herearethedescriptionsofeverysetupitem:
Item Description
EnableRS‐485 CheckthisboxtoenableRS‐485functionality.
UsePelco‐D SelectthisoptionandRS‐485inte rfacewilloutputpan‐tile
controlsignalinPelco‐Dformat.Thisformatiswidely
acceptedbymostofpan‐tiltcameracradles.

Youhavealsoinputpan‐tiltcameracradle’saddresscode
in‘Address’field(numbermustbebetween0~255).This
codemustbeidenticaltopan‐tiltcameracrad le’saddress
code.
UseCustom
Protocol
Whenthepan‐tiltcameracradledoesnotsupportPelco‐D
protocol,youcandefineaprotocol’sdetailbythisfunction.
Pleaserefertopan‐ti ltcameracradle’susermanualto
definetheprotocol.
‐ BaudRate:SelectdatabaudrateofRS‐485interface
thatpan‐tilt
camer acradlewillaccept.Whenthe
lengthofRS‐485connectionisverylong(longer
than200M),it’snotrecommendedtousehigh
speedconnection(greaterthan2400bps).
‐ DataBits:SelectdatabitsofRS‐485connection.
‐ Parity:Selectparitybit:odd,even,orspace.
‐ StopBit:Select
stopbit:1or2.
‐ Home/Up/Down/Left/Right:Inputthecommand
stringusedtomovepan‐tiltcameracradletohome
orup/down/left/rightposition.Youcanclick‘Test’
butt ontosendcommandstringfortesting.
‐ Command1~5:Youcandefineextrapan‐tilt
camer acradlecontrolstringshere
bygivingita
name(CommandName)andcommandstring
(HexadecimalMessage).Youcanalsoclick‘Test’
butt ontosendcommandstringfortesting.
Whenyoufinishwithabovesettings,click‘Apply’buttontosavechanges.


