User manual

56
SSID
Input the SSID of the wireless access point you wish to
connect. It should be less than 32 alphanumerical
characters.
When you select a wireless access point above, it‟s SSID
will be filled in this field automatically. However, if the
SSID is not displayed (the wireless access point you
selected choose to hide it‟s SSID), you have to know it‟s
SSID and input it here, or you will not be able to connect
it.
Channel
Select the radio channel you wish to use here. When
network type is „Infrastructure‟, the radio channel is
auto-selected according to the channel that wireless
access point uses. You can only select the channel
number when network type is „Adhoc‟.
Wireless Key
Input the encryption key of selected wireless access point
here. This is required when access point you wish to
connect uses encryption.
Self PinCode
Here displays the WPS pin code used to connect to
WPS-enabled wireless access points. You have to input
this number into the WPS enabled access point to
establish WPS connection.
Configure via
Push Button
Click this button and this camera will enter PBC-style
WPS connection state for 120 seconds. Please push
„Start PBC‟ button on the wireless access point you wish
to connect within 120 seconds to establish WPS
connection (The remaining time will be displayed on the
button).
If connection can not be established after 120 seconds,
you‟ll be prompted by a message box, and you can press
„Start PBC‟ button to try again.
Configure via
PinCode
If you have wireless access point‟s WPS PIN code, you
can input it here and press „Start PIN‟ button to start to
establish PIN-style WPS connection.