User manual

4
PRODUCT INSTALLATION
In the following there are two ways for your installation. You can
select one that suits you.
Desktop Installation
1. Install the switch on a level surface that can support the weight
of the unit & the relevant components, and attach the rubber feet
to the bottom. The rubber feet cushion the switch and helps
protect the case from scratches.
2. Plug the switch to electrical source with the provided power cord.
Rack-Mount Installation
Rack mounting facilitate to an orderly installation when
series of network devices being installed.
1. Disconnect all the cables from the switch.
2. Place the unit the right way up on a hard, flat surface with the
front facing you.
3. Locate a mounting bracket over the mounting holes on one side
of the unit.
4. Insert the screws and fully tighten with a suitable screwdriver.
5. Repeat the two previous steps for the other side of the unit.
6. Insert the unit into the rack and secure with suitable screws
7. Reconnect all the cables.
Concerning about the installation environment, we strongly recommend:
1. The switch is placed with appropriate ventilation environment. A
minimum 25 mm space around the unit is recommended.
2.The switch and the relevant components are away from sources of
electrical noise such as radios, transmitters and broadband
amplifiers.
3. Avoid from environments beyond recommend moisture.