GP-101SF Quick Installation Guide 10-2014 / v1.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
PRODUCT INTRODUCTION Thanks for purchasing the GP-101SF Gigabit PoE Splitter. The PoE Splitter fully complies with IEEE 802.3af standard, and can work with all IEEE 802.3af PoE compliant PSE (Power Source Equipment) or PoE Injector, to deliver 12V, 9V or 5V DC power to the device which do not support PoE.
Identifying External Components POWER+DATA IN: Connect to the PSE or PoE Injector with a CAT5 UTP cable. DC OUT 5V/9V/12V: You can choose the DC output of 5V, 9V or 12V by adjusting the slide switch to the left or right. ▲ Please make sure that the DC output power is correct, a different voltage may destroy the device. DATA OUT: Connect to the Ethernet device with CAT5 UTP cable to transmit data.
Connecting the PoE Splitter You can use GP-101SF PoE Splitter with PSE or PoE Injector to expand your network to somewhere that has no power line or outlet but you wish to install a device such as APs, IP Cameras or IP Phones, etc. The following steps will tell you how to connect the PoE Splitter correctly. 1. Use a CAT5 UTP cable to connect a PoE port of the PSE (e.g. PoE Switch) to the POWER+DATA IN port. 2. Choose the appropriate DC output by the Power-mode switch.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
EU Declaration of Conformity English: This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC, 2009/125/EC. Cet équipement est conforme aux exigences essentielles et autres dispositions de la directive Français: 2004/108/EC, 2009/125/EC Čeština: Toto zařízení je v souladu se základními požadavky a ostatními příslušnými ustanoveními směrnic 2004/108/EC, 2009/125/EC.
Declaration of Conformity We, Edimax Technology Co., Ltd., declare under our sole responsibility, that the equipment described below complies with the requirements of the European EMC directive (2004/108/EC). Equipment: Model No.
