Operation Manual

40
II-6. WPS Setup
If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use this
method to connect to the EW-7478APC’s Wi-Fi network.
1. Press the WPS/Reset button on the EW-7478APC for 2 seconds to activate WPS.
The LED will then flash blue to indicate that WPS is active.
2. Within two minutes, press the WPS button on the wireless device/client to
activate its WPS.
3. The devices will establish a connection. Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II-7. Reset to Factory Default Settings
If you experience problems with your EW-7478APC, you can reset the device
back to its factory settings. This resets all settings back to default.
1. Press and hold the WPS/Reset button found on the rear base of the
product for at least 10 seconds.
2. Release the button when the LED is flashing blue.
3. Wait for the EW-7478APC to restart.