User manual

4
4. When the WPS connection has been established, the WPS LED will light up
for 5 minutes and the signal strength LED will go on.
Note: If an error has occurred, the WPS LED will flash rapidly. Please
wait for the WPS LED to turn off and try again from the beginning.
5. After you have connected the extender to the existing Wi-Fi network, you
can move this extender to another location for optimal Wi-Fi extension. It
is recommended that you install the extender where the signal strength
LED is on (but not flashing) for better Wi-Fi performance.
Section B: Setting Up the Wi-Fi Extender with a Computer
1. First make sure that your computer is a DHCP client (obtains IP
automatically from DHCP server).
2. Plug the Wi-Fi extender into a power outlet close to the root wireless
access point and switch it on. The power LED should light up in a few
seconds.
3. Connect your computer to the extender with an Ethernet cable. Or connect
your computer to the extender through a wireless connection (search for
the available Wi-Fi networks in the area and connect to
“extenderXXXXXX”).