Installation guide

III. Reset the Extender

If you experience problems with your extender or if you want to change the

extender to a different operating mode, you can reset the device back to its

factory settings. This resets all settings back to default.

1. Press and hold the WPS/Reset button

for at least 10 seconds until the green

power LED is flashing then release the

button.

2. Wait for the extender to restart. The extender is ready for setup when the

green power LED displays on.

IV. WPS

If your wireless router/access point supports WPS (Wi-Fi Protected Setup)

then you can use this method to setup your wireless extender.

1. Press the WPS button on your wireless

router/access point to activate its WPS.

Please check the instructions for

your wireless router/access point for

how long you need to hold down its

WPS button.

2. Within two minutes, press and hold the

WPS button on the wireless extender

for two seconds. The extender’s green WPS LED should flash to indicate

that WPS is in progress.

3. The devices will establish a connection. The extender’s green WPS LED

should display on for 5 minutes to indicate a successful connection.