User Manual

61
Data Rate
Set the wireless data transfer rate. The
default is set to auto.
N Data Rate
Set the data rate of 802.11n. The default is
set to auto.
Channel Width
Select wireless channel width (bandwidth
used by wireless signals from the device) –
the recommended value is Auto 20/40MHz.
Preamble Type
Set the wireless radio preamble type. The
default value is “Short Preamble”.
Broadcast SSID
Enable or disable SSID broadcast. When
enabled, the SSID will be visible to clients as
an available Wi-Fi network. When disabled,
the SSID will not be visible as an available
Wi-Fi network to clients – clients must
manually enter the SSID in order to connect.
A hidden (disabled) SSID is typically more
secure than a visible (enabled) SSID. WPS
(Wi-Fi Protected Setup) is also disabled when
SSID broadcast is disabled.
CTS Protect
Enabling this setting will reduce the chance
of radio signal collisions between 802.11b
and 802.11g wireless access points. It’s
recommended to set this option to “Auto”.
Tx Power
Set the power output of the wireless radio.
You may not require 100% output power.
Setting a lower power output can enhance
security since potentially malicious/unknown
users in distant areas will not be able to
access your signal.