User Manual

FCC Test Report
Report No. : FR442525
SPORTON INTERNATIONAL INC. Page No. : 26 of 57
TEL : [phone] Report Version : Rev. 01
FAX : [phone]
3.5.3 Test Procedures
Test Method
The average emission levels shall be measured in [duty cycle ≥ 98 or duty factor].
Refer as ANSI C63.10, clause 6.9.2.2 bandedge testing shall be performed at the lowest frequency
channel and highest frequency channel within the allowed operating band.
For the transmitter unwanted emissions shall be measured using following options below:
Refer as FCC KDB 558074, clause 11 for unwanted emissions into non-restricted bands.
Refer as FCC KDB 558074, clause 12 for unwanted emissions into restricted bands.
Refer as FCC KDB 558074, clause 12.2.5.1 Option 1 (trace averaging for duty cycle ≥98%)
Refer as FCC KDB 558074, clause 12.2.5.2 Option 2 (trace averaging + duty factor).
Refer as FCC KDB 558074, clause 12.2.5.3 Option 3 (Reduced VBW≥1/T).
Refer as ANSI C63.10, clause 4.2.3.2.3 (Reduced VBW). VBW ≥ 1/T, where T is pulse time.
Refer as ANSI C63.10, clause 4.2.3.2.4 average value of pulsed emissions.
Refer as FCC KDB 558074, clause 11.3 and 12.2.4 measurement procedure peak limit.
For the transmitter bandedge emissions shall be measured using following options below:
Refer as FCC KDB 558074, clause 13.3 for narrower resolution bandwidth (100kHz) using the
band power and summing the spectral levels (i.e., 1 MHz).
Refer as ANSI C63.10, clause 6.9.2 for band-edge testing.
Refer as ANSI C63.10, clause 6.9.3 for marker-delta method for band-edge measurements.
For radiated measurement, refer as FCC KDB 558074, clause 12.2.7.
3.5.4 Test Setup
Transmitter Radiated Bandedge Emissions
Electric field tests shall be performed in transmitter bandedge emissions using a calibrated horn antenna.