Quick Start Guide

III. Reset the Extender

If you experience problems with your extender or if you want to change the

extender to a different operating mode, you can reset the device back to its

factory settings. This resets all settings back to default.

1. Press and hold the WPS/Reset

button for at least 10 seconds and

release when the green power LED is

flashing.

2. Wait for the extender to restart. The

extender is ready for setup when the

green power LED displays on.

IV. WPS

If your wireless router/access point supports WPS (Wi-Fi Protected Setup)

then you can use this method to setup your wireless extender.

1. Press the WPS button on your

wireless router/access point to

activate its WPS.

Please check the instructions for

your wireless router/access point

for how long you need to hold

down its WPS button.

2. Within two minutes, press and hold

the WPS button on the wireless

extender for two seconds. The

extender’s green WPS LED should

flash to indicate that WPS is in progress.

3. The devices will establish a connection. The extender’s green WPS LED

should display on for 5 minutes to indicate a successful connection.