Technical information

2 OF 6
Technical Information
wi -antennas.co.uk
[phone]
www.wifi -antennas.co.uk - Allendale Electronics Ltd, Pindar Road, Hoddesdon, Hertfordshire. EN11 0BZ.
Images & Content ©2010 Allendale Electronics Limited. E&OE - Specifi cations subject to change without prior notice.
2 OF 6
Wireless Range Extender (Universal Repeater) Guide
Once the settings have been entered, open an Internet browser and type 192.168.2.1 on the address bar.
You should then be prompted to log in.
Type in admin as the username and 1234 as the password.
If the log in screen comes back up, it means you might have
already changed the password before so use your customised
password instead.
If you do not know what the customised password is, reset
the access point by pressing the reset button for at least 10
seconds (the blinking power LED will go solid), refresh your
browser page, then try again.
If the page comes back saying “page cannot be displayed”,
check your IP settings to make sure you have saved the
settings properly, if you are sure the EW-7416 has reset
then power cycle, do not power cycle whilst the EW-7416 is
resetting.
Step 2 - Congure EW-7416APN to use Universal Repeater Mode.
If you have logged in successfully you will be presented with a Home summary screen
Click on Basic Setting and you will be presented with a menu similar to the one below:
If the Edimax is at its factory setting Mode will be set to Access Point, Click on the dropdown button and select Universal
Repeater from the list.
Next you need to set the wireless Band to use. If you have replaced an antenna on the Edimax to use it within a point-to-point
system or added an external antenna you will need to change the default B+G+N to B+G using the dropdown button menu.