User Manual

II-6. WPS Setup

In access point mode, if your wireless

device/client supports WPS (Wi-Fi Protected

Setup) then you can use this method to

connect to the EW-7288APC’s Wi-Fi

network. In Wi-Fi bridge mode, you can use

WPS to connect your EW-7288APC to your

existing 5GHz Wi-Fi.

1. Press the WPS button on the

EW-7288APC for 2 – 5 seconds to

activate WPS. The LED will flash blue to

indicate that WPS is active.

2. Within two minutes, press the WPS button on the wireless device/client

(access point mode) or wireless router/access point (Wi-Fi bridge mode) to

activate its WPS.

3. The devices will establish a connection. The LED will display on and blue to

indicate a successful connection.

Please check the instructions for your wireless device for how long

you need to hold down its WPS button to activate WPS.

II-7. Reset to Factory Default Settings

If you experience problems with your EW-7288APC, you can reset the device

back to its factory settings. This resets all settings back to default.

1. Press and hold the WPS/Reset button found on the back panel for at least

10 seconds, until the LED displays on and red.

2. Release the button and the LED will display white and then flash purple.

3. Wait for the EW-7288APC to restart. The EW-7288APC is ready for setup

when the LED is flashing red (no Ethernet cable connected in access point

mode) or displays on and green (Ethernet cable connected in access point

mode or in Wi-Fi bridge mode).