Datasheet

ES-5424P
Maximum performance, actual data rates, and coverage will vary depending on network conditions and environmental factors. Product specifications and design are subject to change without notice.
Copyright © 2018 Edimax Technology Co. Ltd. All rights reserved.
www.edimax.com
Long Range 24-Port Fast Ethernet PoE+ Web Smart
Switch with 4 Gigabit RJ45/SFP Combo Ports
KEY FEATURES
 Twenty-four Fast Ethernet ports and four Gigabit RJ45/SFP combo ports.
 IEEE 802.3af/at PoE compliant.
 Up to 30W per port (total power budget: 280W) for powering PoE-enabled devices.
 PoE long range mode with Ethernet cable to extend up to 200 meters.
 Auto-detection of powered devices (PD) and power consumption levels.
 PoE powered devices (PD) alive check to enhance the reliability of the network.
 Power backfeed protection to avoid damaging the PoE ports.
 DHCP snooping to protect the integrity of legitimate DHCP server and its operations.
 Surge Protection 6KV to avoid the damage of the switch and connected devices.
 Supports SNMP v3, Access Control List (ACL), QoS, CoS, STP, 802.1Q VLAN, IPv4/IPv6, Port Trunk, IGMP
v1/v2/v3 Snooping and Mirror.
 12.8Gbps switch capacity.
 16K MAC address table and jumbo frame support up to 9KB.
 19-inch 1U rack-mount design.
PoE Devices
PoE for Easy Installation and Better Cost Efficiency
Power over Ethernet technology enables the Ethernet cable to carry both data and power, reducing cable installation
and eliminating the need for extension cords or electrical outlets on the walls and ceiling. The ES-5424P can effectively
lower installation costs and simplify deployment effort. The ES-5424P can be used with different PoE products such as
access points, IP cameras or VoIP devices and is an effective solution for network environments where power outlets
are difficult to access.
PoE Powered Device Alive Check
Featuring PoE Powered Device (PD) alive check, the switch can be configured to monitor the real-time status of
connected PDs by ping action (sending alive-checking packets). If a PD fails to respond, the ES-5424P PoE Switch will
reboot the PD, which enhances the reliability of the network and reduces administrator management burden.
DHCP Snooping
The network security feature of DHCP snooping enables the prevention of malicious or malformed DHCP traffic or the
mitigation of security risks from rogue DHCP servers. The function monitors DHCP messages received from untrusted
devices connected to a switching device in the network and protects the integrity of legitimate DHCP server and its
operations.
Smart Tools for Improved Network Efficiency and Security
The switch features smart and simple network monitoring tools that allow for improved network efficiency and security.
The web-based interface management features include QoS (Quality of Service) bandwidth control for better traffic
control, VLAN (Virtual LAN) for enhanced network security and multicast IGMP snooping v1/v2/v3 for streaming
applications. For quick and easy setup, the web-based management integrates advanced management and security
functions of Access Control List (ACL), CoS, STP, IPv4/IPv6, Port Trunk, IGMP v1/v2/v3 Snooping, and Mirror.
Outdoor
Access Point
ES-5424P
PoE Backfeed Protection
PoE Injector
The ES-5424P features 24 IEEE 802.3at Power over
Ethernet (PoE+) ports which supply up to 30W of
electricity per port and has a total power supply of 280W
to power any 802.3at or 802.3af compliant power device.
With PoE detection capability, the ES-5424P is able to
verify whether the connected device is IEEE 802.3at or
802.3af compliant. If a PoE device is not detected, only
network data will be transmitted. Moreover, with the PoE
power backfeed protection from the PoE injectors, the ES-
5424P is able to avoid damaging the PoE ports.
802.3at PoE with Auto Detection & Power Backfeed Protection.