ES-3305P / ES-3308P / ES-3316P Quick Installation Guide 11-2020 / v1.
PRODUCT INTRODUCTION Model: ES-3305P: 5 Port Fast Ethernet Desktop Switch ES-3308P: 8 Port Fast Ethernet Desktop Switch ES-3316P: 16 Port Fast Ethernet Desktop Switch Package Contents Before you start using this switch, please check if there is anything missing in the package, and contact your dealer to claim the missing item(s): Fast Ethernet Desktop switch Quick Installation Guide Power Adapter Front Panel ES-3305P PWR LED LNK/ACT LEDs 1 - 5 ES-3308P PWR LED LNK/ACT LEDs 1 - 8 1
ES-3316P LNK/ACT LEDs 1 - 16 PWR LED LED Status: LED Name Light Status PWR On Off On LNK/ACT Off Flashing Description Switch is on Switch is off Corresponding port is connected Corresponding port is not connected Corresponding port is active and transferring /receiving data.
ES-3316P RJ-45 Ports 1 - 16 5V DC Power Port Operating Environment This switching hub must be installed and operated within the limits of the specified operating temperature 0~40°C (32~104°F) and humidity (10~90% Non-condensing). - Do not place objects on top of the unit. - Do not obstruct any vents at the sides of the unit. - Do not position the unit near any heating source such as a heater, radiator or in direct exposure to sun. - Take care to ensure the unit does not come into contact with water.
Connecting to network devices The RJ-45 ports on the switch support Auto-MDI/MDI-X which allows both straight-through or cross-over type cables to connect this switch to a workstation or hub. Connect one end of the network cable to the RJ-45 port on the rear panel, and connect the other end of the network cable to the RJ-45 port on the network device. Follow the same procedure to connect all RJ-45 ports of the switch.
Connecting the power Connect the power adapter to the power connector of the unit; the green power LED on the front panel should be lit. ES-3305P/ES-3308P ES-3316P TROUBLESHOOTING 1. Power LED is not lit Check if the power cord is properly connected to the external power adapter and the power source. Make sure the DC power jack is firmly plugged into the power socket of the switch. 2.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
EU Declaration of Conformity English: This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/30/EU. Français: Cet équipement est conforme aux exigences essentielles et autres dispositions de la directive 2014/30/EU. Čeština: Toto zařízení je v souladu se základními požadavky a ostatními příslušnými ustanoveními směrnic 2014/30/EU. Polski: Urządzenie jest zgodne z ogólnymi wymaganiami oraz szczególnymi warunkami określonymi Dyrektywą UE 2014/30/EU.
Declaration of Conformity We, Edimax Technology Co., Ltd., declare under our sole responsibility, that the equipment described below complies with the requirements of the European R&TTE directives. Equipment: 5 / 8 / 16-Port Fast Ethernet Desktop Switch Model No.
