ES-3305P V2 / ES-3308P V2 Quick Installation Guide 09-2013 / v1.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
PRODUCT INTRODUCTION Model: ES-3305P V2: 5 Port Fast Ethernet Desktop Switch ES-3308P V2: 8 Port Fast Ethernet Desktop Switch Package Contents Before you start using this switch, please check if there is anything missing in the package, and contact your dealer to claim the missing item(s): Fast Ethernet Desktop switch User manual Power Adapter USB Power Cable Front Panel 5 Port Fast Ethernet Desktop Switch PWR LED LNK/ACT LEDs 1 - 5 8 Port Fast Ethernet Desktop Switch PWR LED LED Status: LED Name
Back Panel 5 Port Fast Ethernet Desktop Switch 5V DC Power Port RJ-45 Ports 1 - 5 8 Port Fast Ethernet Desktop Switch 5V DC Power Port RJ-45 Ports 1 - 8 Operating Environment This switching hub must be installed and operated within the limits of the specified operating temperature 0~40°C (32~104°F) and humidity (10~90% Non-condensing). - Do not place objects on top of the unit. - Do not obstruct any vents at the sides of the unit.
The UTP network cables must comply with EIA/TIA 568 specifications and Category 5 standard for data transmission. The maximum length for a UTP cable segment between the switch and connected devices is 100 meters (300ft). Once the network cable is connected to both ends and the attached network device is powered on, the green LNK/ACT LED should be lit. Connecting the power Connect the power adapter or USB power Cable to the power connector of the unit; the green power LED on the front panel should be lit.
TROUBLESHOOTING 1. Power LED is not lit Check if the power cord is properly connected to the external power adapter and the power source. Make sure the DC power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connected to devices - Ensure that the network device attached to the switch is switched on. - Check the network cable; ensure it is properly connected to the switch and the network device.
Declaration of Conformity We, Edimax Technology Co., LTD., declare under our sole responsibility, that the equipment described below complies with the requirements of the European Council directive (2004/108/EC). Equipment : Model No.
1
