ES-1008PL / GS-1008PL Quick Installation Guide 07-2014 / v1.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
PRODUCT INTRODUCTION Model no.
Front Panel Please refer to the following description for the front panel: *ES-1008PL *GS-1008PL LED Definitions: LED Name Light Status PWR On Off On LINK/ACT Off Flashing Gigabit On (GS-1008PL) Off PoE On Off Description Switch on and correctly powered Switch not powered or not correctly powered The port connected The port not connected The port is activating and transferring /receiving data. There is a 1000Mbps device connected to the corresponding port.
Back Panel: Power Connector: Plug in the female connector of the provided power cord into this AC LINE socket, and the male into a power outlet. Supported input voltages range from 100-240V AC, and 50-60 Hz.
Product Specifications: Model ES-1008PL GS-1008PL IEEE 802.3 10BaseT IEEE 802.3u 100BaseTX IEEE 802.3af/802.3at PoE IEEE 802.3x Flow Control IEEE 802.3az Energy Efficient Ethernet Standards IEEE 802.3 10BaseT IEEE 802.3u 100BaseTX IEEE 802.3ab 1000BaseT IEEE 802.3af/802.3at PoE IEEE 802.3x Flow Control IEEE 802.
1. PRODUCT INSTALLATION There are two ways to install your switch, please select one that suits you. 2. Desktop Installation 1. Install the switch on a level surface that can support the weight of the unit and the relevant components, and attach the rubber feet to the bottom. The rubber feet cushion the switch and helps protect the case from scratches. 2. Plug the switch into an electrical source with the provided power cord. 3.
Troubleshooting 1. Power LED is not lit Check if the power cord is properly connected to the plug and the power outlet; make sure the power cord is firmly plugged into the power socket of the switch. 2. LINK/ACT LED is not lit when connected to devices Make sure the network device attached to the switch is turned on. Make sure the network cable is properly connected to the switch and the network device.
Appendix: The standard RJ-45 Introduction RJ45 Pin: Below is an indication of a standard RJ-45 socket and plug, and definition for the pins. RJ-45 Connector pin signal: Pin no.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
CE Mark Warning This is a class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Declaration of Conformity We, Edimax Technology Co., LTD., declare under our sole responsibility, that the equipment described below complies with the requirements of the European Council directive (2004/108/EC and 2006/95/EC). Equipment Model No.
12
