ES-1008PHE / GS-1008PHE Quick Installation Guide 07-2014 / v1.
COPYRIGHT Copyright Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission from Edimax Technology Co., Ltd. Edimax Technology Co., Ltd.
PRODUCT INTRODUCTION Model no.
Front Panel Please refer to the following description for the front panel: *ES-1008PHE *GS-1008PHE LED Definitions: LED Name Light Status PWR On Off On LINK/ACT Off Description Switch powered on Switch not powered The port is connected to 100M network The port is not connected or connected to 10M network Flashing The port is transmitting /receiving data. Gigabit On There is a 1000Mbps device connected to the (GS-1008PHE) corresponding port.
Back Panel: *ES-1008PHE *GS-1008PHE Power Connector: Plug in the DC power plug from provided power adaptor to the 48V DC IN jack and plug the AC power plug to the wall socket using the included power cord. Terminal Block: Used for connection to auxiliary backup DC power, supported input voltages is DC 48V/1A.
Product Specifications: Model ES-1008PHE IEEE 802.3 10BaseT IEEE 802.3u 100BaseTX IEEE 802.3af PoE IEEE 802.3x Flow Control IEEE 802.3az Energy Efficient Ethernet Standards GS-1008PHE IEEE 802.3 10BaseT IEEE 802.3u 100BaseTX IEEE 802.3ab 1000BaseT IEEE 802.3af PoE IEEE 802.3x Flow Control IEEE 802.
1. PRODUCT INSTALLATION I. Install the switch on a level surface that can support the weight of the unit and the relevant components, and attach the rubber feet to the bottom. The rubber feet cushion the switch and helps protect the case from scratches. II. Plug the switch into an electrical source with the provided power cord. Regarding the installation environment, we strongly recommend: 1. The switch should be placed in an appropriately ventilation environment.
Appendix: The standard RJ-45 Introduction RJ-45 Pin: Below is an indication of a standard RJ-45 socket and plug, and definition for the pins. RJ-45 Connector pin signal: Pin no.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
EU Declaration of Conformity English: Français: Čeština: Polski: This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC and 2006/95/EC Cet équipement est conforme aux exigences essentielles et autres dispositions de la directive 2004/108/EC and 2006/95/EC Toto zařízení je v souladu se základními požadavky a ostatními příslušnými ustanoveními směrnic 2004/108/EC and 2006/95/EC Niniejszym (Edimax) oświadcza, że (ES-3305P / ES-3308P/ ES-3116P) je
Declaration of Conformity We, Edimax Technology Co., LTD., declare under our sole responsibility, that the equipment described below complies with the requirements of the European Council directive (2004/108/EC and 2006/95/EC). Equipment Model No.
11
