User`s guide

Rear Panel
Figure 1-3: Rear Panel
AC 100V ~ 240V
Connects to AC100~240V / 50~60Hz with supplied AC power cord.
Default Settings
When the Multi-WAN VPN Link Balancer has finished booting, all configuration settings will be set
to the factory defaults, including:
• IP Address set to its default value of 192.168.1.1, with a Network Mask of 255.255.255.0
• DHCP Server is enabled
• User Name: admin
• Password cleared (no password)
TFTP Download
This setting should be used only if your Multi-WAN VPN Link Balancer becomes unusable and you
are attempting to restore it by upgrading the firmware. Follow this procedure:
1.
2.
Power-On the Multi-WAN VPN Link Balancer.
Use the supplied Windows utility or a TFTP client program to apply the new firmware. If using the
supplied Windows TFTP program, the screen will look like the following example:
Figure 1-4: Windows TFTP utility
• Enter the name of the firmware upgrade file located on your PC, or click the "Browse" button
to locate the file.
• Enter the LAN IP address of the Multi-WAN VPN Link Balancer in the "Server IP" field.
• Click "Upgrade Firmware" to send the file to the Multi-WAN VPN Link Balancer.
3. When the upgrade is finished, the Multi-WAN VPN Link Balancer should work normally. The
factory default settings will be applied.
Page 7