User`s guide

1. First, you have to “Enable” QoS, once you have enabled it. It will start QoS mechanisms.
2. From now on, you can dispatch the network bandwidth (inbound /outbound) to the WAN ports.
By default, the device dispatches each WAN port for inbound & outbound is 6400 kbit/sec
(51200/8)=6400 kbit/Sec. However, your local ISP provides the real bandwidth for each WAN
bandwidth. Therefore, you fill-out the inbound & outbound bandwidth that your local ISP offer to you.
3. Once you fill-out each WAN port bandwidth, then you can move to the next step, setting up each
WAN port inbound/outbound bandwidth policy.
(B)
Figure 8-4: Policy Configuration
Page 72