User`s guide

Settings – QoS Policy
WAN Inbound
/ Outbound
Policy
• Policy Name –The name of a policy which is used to classify the received
packets based on the following types for your memory
• Local / Remote Address, Port –Specify a packet based on Local/Remote
address or port. Address has two types: IP address and MAC address. By
default, the IP address is 0.0.0.0 for all IP Addresses but the MAC address is
00-00-00-00-00-00 which cannot be used to classify.
Port and Protocol Type define all packets for special applications
• Protocol Type – The field defines traffic packet type, i.e. IP, TCP and UDP.
• Maximum Guaranteed Bandwidth –This device supports Bandwidth
queues. When a packet meets a policy rule requirement, it will be put into the
responding queue. The queue will send them use the guaranteed bandwidth.
If the rest bandwidth is enough it will try to arrive the maximum bandwidth.
Teaching setup Bandwidth control QoS:
The following is teaching you how to setup bandwidth control QoS.
( A)
Figure 8-3: Policy Configuration
* 51200 k bit/Sec is the maximum bandwidth that device CPU can handle.
Page 71