User`s guide

Routing
This section is only relevant if your LAN has other Routers or Gateways.
• If you don't have other Routers or Gateways on your LAN, you can ignore the Static Routing
page completely.
• If your LAN has other Gateways and Routers, you must configure the Static Routing screen as
described below. You also need to configure the other Routers.
Figure 4-2: Routing
Note:
If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries.
You cannot modify or delete these entries.
Settings – Routing
Dynamic
Routing
• RIP v2 – This acts as a “master” switch. If enabled, the selected WAN or LAN
will run RIPv1/v2, otherwise RIP function will not be available.
• Interface – If LAN or other WAN are enabled, the specified WAN or LAN can
execute RIP function.
Page 31