I O N A L A N P O F E S S R L Gigabit Ethernet Adapter 10/100/1000Mbps PCI Gigabit Ethernet Adapter EN-9230TX-64/32 User’s Manual
FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits of a Class B computing devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
11 Introduction Thank you for purchasing our Gigabit Ethernet Adapter. This guide is to provide the installation and usage of this adapter for network installers and users. The Gigabit network adapter complies to 64-/32-bit (EN-9230TX-32 supports 32-bit only) PCI specification and supports half/full- duplex feature which can double network speed.
22 Features & Specifications (1) Features & Benefits y Supports 64-/32-bit (EN-9230TX-32 supports 32-bit only), 66/33MHz PCI Local Bus Master Version 2.2/2.1. y Comply with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x. y Supports IEEE 802.3x full duplex flow control. y Supports IEEE 802.1Q VLAN tagging. y Supports Wake On LAN power management function. y Supports Jumbo Frame. y Plug and Play installation, auto-setup IRQ and I/O address. y Auto-Negotiation, full/half- duplex.
(2) Technical Specification y Topology : Star y Connector : RJ-45 y Standard : IEEE 802.3 10BaseT IEEE 802.3u 100BaseTX IEEE 802.3ab 1000BaseT y Transmission Rate : 10Mbps/20Mbps 100Mbps/200Mbps 1000Mbps/2000Mbps y Hardware Required : IBM compatible PC with available PCI slot (PCI 2.2/2.1), 64-/32-bit, 66/33MHz y IRQ Line : Assigned by system y I/O Address : Assigned by system y Drivers : Windows 98/98SE/Me/NT Windows 2000/XP, Netware Server 5.x/6.
33 Installation (1) Hardware Installation To insert the network adapter into your PC, follow the steps as below : 1. Turn off the computer and remove its cover. 2. Insert the adapter into a PCI slot. 3. Secure this adapter to the rear of the computer chassis and put back the computer cover. 4. Connect the adapter to the network using twistedpair cable. (2) Driver Installation Use the drivers supplied by the diskette included in this product. For detail description, please execute the readme.
44 Trouble-shooting If you experience any problems with the adapter, please make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub/switch complies with the adapter specification, such as 10Mbps 10BaseT, 100Mbps 100BaseTX and 1000Mbps 1000BaseT, then check the LED. The adapter provides LEDs to indicate network status. Speed The LED indicates the adapter is connected to 10BaseT, 100BaseTX, or 1000BaseT network.
TRADEMARKS Copyright 2004/2005 by the manufacturer of this product. No part of this manual may be reproduced, transcribed, stored in a retrieval system, translated into any language or computer language without the prior written consent of the manufacturer. All brand and product names are trademarks and/or registered trademarks of their respective companies.
