Installation guide

11. Please set the network settings for the Print Server manually. By default, the
network settings are as follows.
IP Address: 192.168.2.2
Subnet Mask: 255.255.255.0
If you have selected “DHCP”, the Print Server will try to determine the network
settings automatically. If a DHCP Server is present within the network, the Print
Server will automatically obtain and configure the network settings assigned by the
DHCP Server. The assigned IP Address will be shown in the IP Address fields. If no
DHCP Server is present within the network, please assign the network settings of
the Print Server manually. Please click “Next” once you have found appropriate
network settings for the Print Server.
Note: The Print Server IP Address must be set to have the same network segment
within your network environment or connected computer. If the network IP address
settings are incorrect, then print server will not be able to communicate throughout
the network. For example, if your router/gateway/computer is using IP address
192.168.2.1, then you need to give a unique manual IP to your print server with IP
range 192.168.2.x (Please note: Above IP address setting is only an example,
please do not follow exactly!)
If the network settings are incorrect, a message will be prompted to remind you after
you click “Next”. If you do not want to set it now, please click “Cancel” to finish the
installation. You can then use the “Server Manager” utility to configure the Print
Server IP address.