User Manual

200
Wireless
Enable or disable the AP’s 5GHz wireless radio. When disabled,
no 5GHz SSIDs will be active.
Band
Wireless standard used for the AP.
Combinations of 802.11a, 802.11n & 802.11ac can be selected.
Enable SSID
Number
Select how many SSIDs to enable for the 2.4GHz frequency
from the drop down menu. A maximum of 16 can be enabled.
SSID#
Enter the SSID name for the specified SSID (up to 16). The SSID
can consist of any combination of up to 32 alphanumeric
characters.
VLAN ID
Specify a VLAN ID for each SSID.
Auto
Channel
Enable/disable auto channel selection. Auto channel selection
will automatically set the wireless channel for the AP’s 5GHz
frequency based on availability and potential interference.
When disabled, configurable fields will change as shown
below:
Auto
Channel
Range
Select a range to which auto channel selection can choose
from.
Auto
Channel
Interval
Select a time interval for how often the auto channel setting
will check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are
connected” box according to your preference.
Channel
Bandwidth
Select the channel bandwidth:
20MHz (lower performance but less interference); or
Auto 40/20 MHz; or
Auto 80/40/20 MHz (automatically select based on
interference level).
BSS
BasicRateSet
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.